Genau die gleiche Frage habe ich mir gestern auch gestellt.
Angeblich soll es seitens OCZ ein toll geben, mit dem das geht.
Mit der Tool Box geht es nicht.
Woran man es allerdings erkennen kann ist die Firmware, bei den 24er gibt es erst ab einer bestimmten Version.
Habe eine Firmware Version die offiziell keine 24er unterstützt, dennoch nur 55 GB. Falls jemand eine Lösung hat das festzustellen, bitte posten ![]()
Wobei bei mir die Daten noch recht gut aussehen.
@ den TE:
Lade dir mal das OCZ Tool herunter und poste was bei dir unter SMART steht.
Evtl. hilft das weiter, bei mir sieht es z.B. so aus:
ZitatAlles anzeigenSMART READ DATA
Revision: 10
Attributes List
1: SSD Raw Read Error Rate Normalized Rate: 102 total ECC and RAISE errors
5: SSD Retired Block Count Reserve blocks remaining: 100%
9: SSD Power-On Hours Total hours power on: 508
12: SSD Power Cycle Count Count of power on/off cycles: 119
171: SSD Program Fail Count Total number of Flash program operation failures: 0
172: SSD Erase Fail Count Total number of Flash erase operation failures: 0
174: SSD Unexpected power loss count Total number of unexpected power loss: 10
177: SSD Wear Range Delta Delta between most-worn and least-worn Flash blocks: 0
181: SSD Program Fail Count Total number of Flash program operation failures: 0
182: SSD Erase Fail Count Total number of Flash erase operation failures: 0
187: SSD Reported Uncorrectable Errors Uncorrectable RAISE errors reported to the host for all data access: 0
194: SSD Temperature Monitoring Current: 1 High: 129 Low: 127
195: SSD ECC On-the-fly Count Normalized Rate: 102
196: SSD Reallocation Event Count Total number of reallocated Flash blocks: 0
231: SSD Life Left Approximate SDD life Remaining: 100%
241: SSD Lifetime writes from host Number of bytes written to SSD: 384 GB
242: SSD Lifetime reads from host Number of bytes read from SSD: 640 GB