Dann frage ich gleich mal direkt. Kannst du Englisch?
Wenn ja, dann nimm den zweiten Link von oben und lies die Anleitung durch.
Ansonsten, hier der ganze Eintrag:
USING BNU
When running BNU, avoid using any other software which
purports to enhance communications products (such as
16550.EXE). These WILL NOT work, and could cause your system
to crash or work unreliably. BNU already uses the 16550 and
16550AN to full advantage.
Avoid loading DOS's MODE command with BNU. BNU is
incompatible with it's communications handling - if loaded
after BNU, then both may fail to operate reliably. Printer
redirection is usually ok, provided MODE is loaded before
BNU.
If you need to set a COM port's baud rate (which is why MODE
is most often used), then you can get BNU to do that by
"locking" the baud rate (using BNU /L as documented below)
which sets the COM port immediately to that rate. Remember
to "unlock" the baud rate if not using a constant speed
between computer and modem.
BNU.COM would normally be loaded in your AUTOEXEC.BAT, and
installed as part of your normal system startup. A typical
command line might be:
BNU /F
[Loads BNU.COM with default settings and fast ANSI]
BNU will respond with a short copyright notice and an
indication that it has been successfully loaded. The number
of ports installed for will also be shown.